Thursday, December 27, 2012

The Dremel as a router


I spent a lot of time inlaying butterfly joints in the slabs this past week. It's a lot of material to remove, and this project has been lagging, so I decided to go with the less traditional methods of waste removal. I drilled out holes with the cordless drill, and then proceeded to handle waste removal with a Dremel tool mounted in the router base that's made by Stewart MacDonald. The butterfly joints go pretty deep, so I went with one of the high speed spiral bits to help handle trimming, since the cutting edge is full length, and they're long enough for the job.

As a hand tool purist, I would be disgusted with myself if it didn't feel so much closer to a hand tool in use than a regular router does. It's slow and steady, pretty controllable, and because it's underpowered, (and because it was cutting through an inch of walnut) it offered more tactile feedback than a regular router would: A full-strength router might buck just enough to let you know it ruined something as it goes by, but not necessarily. So I'm pretty happy with this setup.

There's only one real problem, and it's the reason the ear muffs are in the photo. It sounds almost exactly like this:


No comments: